All-in-One System Open Frame Monitor Industrial Computer Chassis Video Capture Solutions Industrial Computing Solutions PowerSupply/ Peripherals A partnership with IEI does not end at product shipment. We’re beside you with ongoing product support as your products evolve and change 1. Power supply without any control signal 2. Power is controlled directly by the power supply's on/off switch. 2. Power supply on/off control by “PS_On#” signal. 3. PS_On# is an active low signal that turns on all power rails. 1. The 5 V standby power is not provided to the SBC. 2. Power supply power is controlled by the "PS_On#" signal. 3. The power switch is connected to the power supply. Set the jumper on the power modules and SBC to AT mode (if available) Connect all input and output power cables Wire/Isolate DC input by power switch Power up by switch Power Switch DC Input or DC Output PM Series 2-pin jumper available for AT/ATX mode selection IDD Series SBC AT or ATX Mode Selection: It could be either auto detect or jumper select. Please consult with the SBC vendors. Set the jumper on the power modules and SBC to ATX mode (if available) Wire 5VSB and PS_ON# from power module to SBC Wire all input, output power cables Power up system by SBC on/off switch DC Input or PM Series IDD Series 2-pin jumper available for AT/ATX mode selection PS_On# 5VSB DC Output 2-pin ATX Power Button Connector SBC On/Off Switch Set the jumper on the power modules to ATX mode and set the jumper on the SBC to AT mode (if available) Connect 5VSB & PS_ON# from the power module to the SBC. Connect all input and output power cables. Power up the system using the power switch connected to the SBC. DC Input or IDD Series PM Series 2-pin jumper available for AT/ATX mode selection PS_On# DC Output On/Off Switch